Seyed Sadegh Ghasemi Banadkouki
Yazd University
H-index: 17
Asia-Iran
Top articles of Seyed Sadegh Ghasemi Banadkouki
Investigation of Micromechanical Properties of Martensite and Ferrite Microphases in a 35CHGSA Medium‐Si Low‐Alloy Steel
steel research international
2024/1/2
Ali Khajesarvi
H-Index: 2
Seyed Sadegh Ghasemi Banadkouki
H-Index: 12
Seyed Abdolkarim Sajjadi
H-Index: 25
Effect of Carbon Partitioning on Abnormal Martensite Hardening in a Conventional Quench and Temper Medium Silicon Low Alloy Steel under Ferrite-Martensite Dual-Phase Microstructure
HTM Journal of Heat Treatment and Materials
2023/5/30
Abnormal Trend of Ferrite Hardening in a Medium-Si Ferrite-Martensite Dual Phase Steel
Metals
2023/3/8
Fundamentals Design and Set up Radial Inflow Gas Turbine Research Lab
Journal of Computational Methods in Engineering
2022/12/31
Fabrication of Mullite-Alumina-SiC Composites by In-Situ Reaction during Carbothermal Reduction of Inorganic Materials
Journal of Advanced Materials in Engineering (Esteghlal)
2022/12/31
Effect of Carbon Partitioning and Residual Compressive Stresses on the Lattice Strains of Retained Austenite During Quenching and Isothermal Bainitic Holding in a High‐Silicon …
steel research international
2022/4
Effect of tempering heat treatment on mechanical properties of a medium silicon low alloy ferrite–martensite DP steel
Int. J. Iron Steel Soc. Iran
2022/1/21
Ali Khajesarvi
H-Index: 2
Seyed Sadegh Ghasemi Banadkouki
H-Index: 12
Seyed Abdolkarim Sajjadi
H-Index: 25
Characteristics and Kinetics of Bainite Transformation Behaviour in a High-Silicon Medium-Carbon Steel above and below the Ms Temperature
Materials
2022/1/11
Seyed Sadegh Ghasemi Banadkouki
H-Index: 12
Mahesh Somani
H-Index: 25
Effect of Ferrite and Martensite Hardening Variation on Mechanism of Void Formation in Low-Alloy Dual-Phase Steel
Metallography, Microstructure, and Analysis
2021/10
Color light metallography versus electron microscopy for detecting and estimating various phases in a high-strength multiphase steel
Metals
2021/5/23
Improvement of load bearing capacity of Al-1100 joining area by using In-situ synthesizing of Al/Cr during FSSW
2020/1/1
Effect of martensite volume fraction on abnormal work hardening behavior of a low carbon low alloy ferrite–martensite dual-phase steel
International Journal of Materials Research
2020/12/1
Seyed Sadegh Ghasemi Banadkouki
H-Index: 12
Investigation of Abnormal Mechanical Behaviour of a Low Alloy Spring Steel containing 0.5 wt% C-1.7 wt% Si Under Bainitic-Martensitic-Retained Austenitic Condition
Journal of Metallurgical and Materials Engineering
2020/9/22
بررسی رفتار مکانیکی غیرمتعارف فولاد کمآلیاژ فنر حاوی% wt Si7/1% wt C-5/0 در شرایط سه فازی بینیتی-مارتنزیتی-آستنیت باقیمانده
مهندسی متالورژی و مواد
2020/9/22
Investigation of carbon and silicon partitioning on ferrite hardening in a medium silicon low alloy ferrite-martensite dual-phase steel
International Journal of Iron & Steel Society of Iran
2020/8/22
Abnormal mechanical response in a silicon bearing medium carbon low alloy steel following quenching and bainitic holding versus quenching and partitioning treatment
Journal of Materials Research and Technology
2020/5/1
Microstructural evolution in a high-silicon medium carbon steel following quenching and isothermal holding above and below the Ms temperature
Journal of Materials Research and Technology
2020/5/1
On the decomposition of austenite in a high-silicon medium-carbon steel during quenching and isothermal holding above and below the Ms temperature
Materials Characterization
2020/4/1
M. Carsí, J. Llaneza, F. Carreño, OA Ruano
Int. J. Mater. Res.(formerly Z. Metallkd.)
2020
