Ning Guo
Southwest University
H-index: 28
Asia-China
Top articles of Ning Guo
Microstructure and defects of rectangular Cu-Ag wires fabricated by the continuous extrusion forming process
Canadian Metallurgical Quarterly
2024/1/2
Effect of Hot Torsion on Microstructure and Properties of Precipitation Hardening Martensitic Stainless Steel
Journal of Materials Engineering and Performance
2024/1
Effect of high current pulsed electron beam on surface microstructure and properties of cold-rolled austenitic stainless steel
Journal of Materials Research and Technology
2024/3/1
Influence of laser power on microstructure and high-temperature tribological properties of CoAlTiWTa RHEA coating on Inconel 718 superalloy
Surface and Coatings Technology
2024/2/19
Gradient Cr–AlN composite coating prepared on alumina-forming austenitic steel
Surface Engineering
2024/1/15
Influence of the Hot-Pressing Rate on the Interface Feature and Mechanical Properties of Mg/Al Composite Plates
Metals
2023/12/24
Enhancing tensile properties of extruded AZ31 rod by introducing gradient bimodal microstructure
Transactions of Nonferrous Metals Society of China
2023/12/1
Insights into the corrosion mechanism of a 12Cr F/M steel in oxygen-saturated liquid LBE
Corrosion Science
2023/12/1
Discharge and corrosion behavior of Mg–2Zn–Mn–xY alloys as the anode for Mg-air battery
Journal of Materials Science
2023/9
Excellent Strengthening of Low-Carbon Steel by Severe Free-End Torsion
Metals and Materials International
2023/8
Corrosion and discharge behavior of Mg− Zn− Mn− Nd alloys as primary Mg− air batteries anode
Transactions of Nonferrous Metals Society of China
2023/7/1
Influence of initial {10− 12} twins on twinning behavior of extruded AZ31 alloys during free-end torsion
Materials Characterization
2023/7/1
Promoting hybrid twins structure to reduce yield asymmetry of rolled AZ31 plates by combining side-rolling and torsion
Journal of Magnesium and Alloys
2023/6/1
Effect of tempering and partitioning (T&P) treatment on microstructure and mechanical properties of a low-carbon low-alloy quenched and dynamically partitioned (Q-DP) steel
Materials Science and Engineering: A
2023/5/8
Achieving excellent mechanical properties of ODS steel by Y2O3 addition
Materials Science and Engineering: A
2023/5/8
Surface microstructures and properties of oxide-reinforced FeCrAl matrix composite coatings prepared by laser cladding on a ferritic-martensitic steel
Journal of Nuclear Materials
2023/5/1
Laser-clad FeCrAl/TiC composite coating on ferrite/martensitic steel: Significant grain refinement and wear resistance enhancement induced by adding TiC
Surface and Coatings Technology
2023/3/15
Effect of Sm addition on the microstructure and mechanical properties of Mg–xSm–0.4 Zr alloys
Journal of Materials Research and Technology
2023/3/1
Laser-cladded Al-Cr-Ti ternary alloy coatings on Ti-4Al-2V alloy: Specific microstructure and enhanced surface performance
Surface and Coatings Technology
2023/1/15
The as-cast AlxCrTaTi refractory medium entropy alloys with good room-temperature mechanical properties and high-temperature oxidation resistance
Journal of Alloys and Compounds
2023/1/15
Ning Guo
H-Index: 18
Ning Li
H-Index: 7